iFire CRM 43, Руководство по установке

Страница: 10 / 12

9
Photo.1
Photo.2
Photo.4
Photo.5
ATTENTION: Never fill the burner from its
main opening because there might be small
hearths , non visible. To fill the burner with
Bioethanol, always use the special tools to
control the flow of the fuel (Photo 4). Thus,
avoid the case of fuel being spilled out and
around of the burner’s hole, while we make
sure that our ignition will be completely
safe. Place the filling funnel into the filling
hole and fill with attention using a vessel,
(Photo 5). The filling is realized in 2 parts.
During the first filling, as soon as the fuel
has reached the upper surface of the
stone, stop for 10-15’’, letting it absorb a
part of the existent fuel. By the passage of
the 10-15’’, when the fuel level has
been a little lessened, repeat the same
procedure till the fuel level reaches again the
upper surface of the stone.
Now the burner is completely filled.
On the surface of the burner there is a
special filling (Photo 1). Check that the
cover opens and closes properly.
ATTENTION! At its initial position always
close the cover of the burner and open the
special filling hole (Photo 2).
Photo.3
To place the Burner in the special hole into
the built-in fireplace construction, use the
special handle for Burner’s placement as
presented on the left photo (Photo 3). Use
the same special handle also in case you
need to move/remove the Burner from this
position.