IEMCA Smart 320 Tp, Руководство по эксплуатации и техническому обслуживанию

Страница: 48 / 146

EN
4 - HANDLING AND INSTALLATION SMART320
4 - Pag. 12 / 26
• check with a sliding caliper, the alignment
near bushing (C) and spindle (D); use a
tolerance of ± 0.15 mm in the four directions.
• prepare a perfectly straight ground bar, with
an external diameter equal to the maximum
spindle bar passage and with a length equal to
the double coupling distance (see (B) in the
“Preliminary Positioning” paragraph, Chap. 4);
• place the bar in the guide channel and cause
it to slide forwards and backwards in the
spindle, until the lathe collet area is reached.
POSITIONING ADJUSTMENTS
After checking the alignment of the bar feeder
with either the thread or the bar, any required
corrections should be carried out.
Adjust height by turning the screws in the
support feet; carry out lateral adjustments with
calibrated mallet blows on the sides of plates (E).
During this phase, any adjustment carried out
during the levelling phase should be preserved;
therefore, in most cases, it is necessary to find
the correct adjustment of the bar feeder position.