IDEATEC S.A. - Z.I. de Noville-les-Bois - rue Léopold Génicot 19A - 5380 Fernelmont, Belgium - Tel: +32(0)81 42 00 10 - E-mail: [email protected]
User Guide PPS-TWIN
V1.0 - Module V1.7
Page 15
5.
5mm
MAX
Fig.1
Fig.2
*available soon
*
5.2 FSP-4K, FSP-6K and FSP-9K Installation (continued)
Ü
Choose the best place to install the console in the vehicle.
Ü
Locate and note the 2 fixation holes on the back side of the console (Fig.1).
Ü
Place the console perfectly.
Ü
Block the 2 head screws provided.
Ü
ATTENTION: The force applied to tighten the screw depends on wall type. It must never be too high. The
manufacturer will not provide repairs under warranty if the back side of the console is broken due to exceeded
tightening force.
Ü
Preassemble the console without blocking the 2 hexagonal head screws.
Ü
Choose the best place to install the console on the dashboard.
Ü
Locate and note the 6 fixation holes at the base of the foot (
18).
page
Ü
Fix the base and position the console perfectly.
Ü
Block the 2 hexagonal head screws.
Ü
Attach the cover to the back of the foot with the screw provided.
Ü
Place the small black cap on the head of the screw on the back.
Use only screws, nuts, and washers provided by the
manufacturer.
Using other, longer screws in the back of the console
may seriously damage its internal parts.
The manufacturer cannot assure any warranty or
accept liability if other fixing elements or screw, nuts,
and washers are used to install the console.
Elements installation (continued)
5.2.4 FSP-6K and FSP-9K with housing - foot mouting
5.2.5 FSP-4K, FSP-6K and FSP-9K with housing - wall mouting
