IDEAL Response SE, Инструкция по установке и обслуживанию

Страница: 19 / 60

19
Response SE Combi -
Installation
Res1483
1
2
3
4
5
6
7
8
9
INSTALLATION
21 SIDE FLUE ASSEMBLY - Exploded view
IMPORTANT.
For direct mounting (piping frame on wall)
choose one black circle in each group.
If using the stand-off brackets choose one
dotted circle in each group. Care MUST be
taken to ensure the correct holes are drilled.
1. Tape the template into the selected
position.
2. Ensure squareness by hanging a
plumbline as shown.
3. Mark onto the wall the following:
a. The 4 wall mounting plate screw
positions.
b. The position of the flue duct.
Mark the centre of the hole as well as
the circumference.
Note. Allow for stand-off brackets if
being used. Use the table on the wall
mounting template.
4. Remove the template from the wall.
22 WALL MOUNTING TEMPLATE
2. When cutting the
ducts always use the
cardboard support
cutting aid provided.
1. An optional flue duct extension kit is
required for flue lengths greater than :
410 mm (16") for RHS flue
540 mm (21
1/4
") for LHS flue
(Refer to Frame 11).
LEGEND
1. Terminal.
2. Weather seal.
3. Duct assembly.
4. No. 8 x 8 self-
tapping screw.
5. M5 x 10 pozi screw.
6. Turret clamp
7. Turret seal
8. Flue turret
9. Inner flue seal.
REAR FLUE OUTLET