IDEAL IMAX XTRA EL, Установка и обслуживание

Страница: 34 / 58

34
SERVICING
IMAX XTRA EL
- Installation & Servicing





36 CASING REMOVAL
TO REMOVE FRONT AND SIDE PANELS
1. Refer to frame 34
2. Lift the control pod upwards to disengage. This can then be
located in the raised position using the location hooks.
3. Remove the 2 securing screws from the front panel.
4. Angle the front panel forward and lift to disengage the panel
and remove.
5. Slide the front side panel forward and lift to disengage from
the fixing locations
6. Slide the rear side panel forward and lift to disengage from
the fixing locations.
7. Repeat steps 5 and 6 to remove the remaining side panels.
8. Re-fit in reverse order.
Note; only the two front side panels have
noise dampening insulation fitted
SER
VICING
37 REMOVAL OF BURNER MANIFOLD
1. Refer to Frames 34 & 36.
2. Remove the four nuts securing the burner hood elbow to
the heat exchanger.
3. Remove the four bolts securing the burner hood elbow to
the interface plate.
4. Lift the burner hood elbow and carefully clear the heat
exchanger studs.
5. To Refit: Inspect the sealing gaskets for damage and
replace as necessary.
6. Align the burner head elbow and engage the studs on the
heat exchanger.
7. Loosely fit the four securing bolts to locate the elbow on the
interface plate.
8. Loosely fit the four securing nuts to the heat exchanger studs.
9. With all fixings in position, tighten in sequence to ensure
the burner hood elbow is correctly secured on the interface
plate and the heat exchanger.
10. Check for any leakage on all seals.