ideal commercial VICEROY GTS 8, Установка и обслуживание

Страница: 23 / 36

23 Viceroy GTS -
Installation & Servicing
INSTALLATION
30 INSTALLING THE CONTROL PANEL
1. Route the sensors through the left or right hand opening in
the front top panel.
2. Route the burner leads through the other opening in the
front top panel.
3. Lower the control panel onto the location buttons nearer the
front and slide the control panel forwards.
4. Remove the three screws from the rear of the control
panel and remove the top/rear cover.
5. Secure the control panel to the casing top front
panel with two self tapping screws and shakeproof
washers provided.
6. Pull the mains cable and any other sensors into the
control panel through the appropriate opening ready
to make the connections.
Front
Rear
vic7105
3
4
5
vic7106
31 INSTALLING THE SENSORS AND ROUTING THE BURNER CABLE
1. Route the burner cable inside the
front edge return of one side of the
casing side panels opposite the burner
hinges. (RH side shown for clarity.
See Frame 32.)
Carefully unroll and take out the
various sensors from the control panel
and pass them through the opening in
the front top cover panels.
2. Insert the sensors into the sensor
pocket.
3. Loop the sensor leads back over the
sensor pocket.
4. Secure the leads with the spring clip.
vic9120
INST
ALLA
TION