IDC Mikro, Руководство пользователя

Страница: 33 / 44

33
A P P L I C A T I O N A N D O P E R A T I O N
E N
6 Application and Operation
6.1 Changing the blank holder
In delivery condition, the milling machine is
equipped with a 71 blank holder.
To change the blank holder:
▷
With the door closed, press operation button [A]
for at least three seconds.
The current tool is placed down. The blank
holder [2] moves to the change position.
Fig. 9
1 Fastening screw for blank holder
2 Blank holder
▷
Loosen fastening screw [1].
▷
Pull off the blank holder toward the right.
▷
Clean the locating bore and surfaces.
▷
Check the pin of the blank holder and clean if
required.
▷
Insert the blank holder with the pin to the stop
in the locating bore.
▷
Tighten fastening screw [1] with with the sup-
plied torque wrench.
▷
Briefly press operation button [A].
The machine advances to the starting position.
WARNING:
Danger from shavings/chips or tool fragments
being thrown from the machine!
▷
Make sure that the door of the milling machine
is always closed during processing!
NOTE:
Insufficient milling results and increased wear
when dry processing!
▷
Do not operate the milling machine without
extraction!
1
2
NOTE:
Inaccurate working results or damage to the
blank-holder fixture possible!
▷
Tighten fastening screw [1] with a torque of
4 Nm.
The torque wrench included in the delivery
scope is appropriately set.
OBJ_DOKU-0000004940-001_de_en.fm Page 33 Thursday, April 30, 2015 2:34 PM