When connecting to a controller that is running firmware version 2.08.886 or higher, module comms and TLCD
comms ports (9450 & 9460) over ethernet are disabled by default. You will need to enable these ports for the
module to communicate with the controller, by adding commands to the controller programming.
⦁
To enable Module Comms UDP/TCP (9450) add the commands:
EnableModuleUDP = true
EnableModuleTCP = true
⦁
To enable Touch Screen Comms UDP (9460) add the command:
EnableTLCDCommsUDP = true
Restart Device
Use this option to restart the module.
Device Information
The device information page displays the serial number, hardware revision, and firmware version of the receiver
module.
This page is also used to upgrade the module's firmware by putting the device into boot mode then transferring a
firmware file to the device by TFTP.
User Management
The module comes with two default users:
Username
Password
admin
admin
user
user
When logged in as admin, the operator can access all pages and change any parameter. In comparison, the user
account permits access to the main (home) and device information pages.
To edit a user, click on the appropriate checkbox, then click
Edit
. This opens a new page where the user settings
can be changed.
For security reasons, we recommend you change the password of the admin user before deployment.
PRT-IVO-IF | Protege Inovonics Wireless Receiver Module | Installation Manual
18
