Defaulting the IP Address
If you don't know the IP address you can set it back to the default address of 192.168.1.3
1.
Locate the default jumper next to the ethernet port on the PRT-IVO-IF side of the board.
The jumper should be in the normal operating position on the two pins closest to the edge of the board.
2.
Power down the unit
3.
Place the jumper on the two pins furthest from the edge of the board
4.
Power up the unit for 30 seconds
5.
Power down the unit
6.
Move the jumper back to its original position.
7.
Power up the unit
PRT-IVO-IF | Protege Inovonics Wireless Receiver Module | Installation Manual
16
