ET-2200 Series Ethernet I/O Modules
Copyright © 2020 ICP DAS CO., Ltd. All Rights Reserved.
-30 -
3.
Getting Started
This chapter provides a basic overview of how to configure and operate your ET-2200 series
module.
3.1
Configuring the Boot Mode
The ET-2200 series modules have two operating modes that can be selected by using the switch
mechanism incorporated on the chassis.
Note that the module must be rebooted after changing the operating mode.
Init Mode
Init Mode should only be selected for troubleshooting.
1. Put the switch in
"Init"
position and then reboot the
module to load factory settings.
2. Use eSearch Utility to reconfigure the module's
network settings.
3. Put the switch back in
"Run"
position and then
reboot the module to work in normal mode.
Run Mode
Run Mode is the default operating mode and should
be used in most cases.
Содержание ET-2200 Series
Страница 20: ...ET 2200 Series Ethernet I O Modules Copyright 2020 ICP DAS CO Ltd All Rights Reserved 20 ET 2251 ET 2254 2254P...
Страница 21: ...ET 2200 Series Ethernet I O Modules Copyright 2020 ICP DAS CO Ltd All Rights Reserved 21 ET 2255 ET 2255U...
Страница 22: ...ET 2200 Series Ethernet I O Modules Copyright 2020 ICP DAS CO Ltd All Rights Reserved 22 ET 2260 ET 2261...
Страница 23: ...ET 2200 Series Ethernet I O Modules Copyright 2020 ICP DAS CO Ltd All Rights Reserved 23 ET 2261 16 ET 2268...