Icom IC-F9011, Руководство пользователя

Страница: 40 / 83

2
Push and hold [PTT] and speak into the
APCO P25 Mode Operation
2
Select the desired Talkgroup ID (or name)
using [CH Up]/[CH Down], or [CH Up/Down].
microphone.
▒ NOTE: Only one station is permitted to speak at a
▒ time.
3
Release [PTT] to receive a response.
▒ NOTE: When the Talkgroup ID is set to ‘65535,’
▒ any Talkgroup call can be received (if NAC is
▒ matched).
▒ NOTE: When ‘65535’ is selected as the
▒ Talkgroup ID, All Call is an open call to
▒ everyone on your system.
3
Push and hold [PTT] to transmit the Talkgroup
call to the specific group, then speak into the
microphone.
• The Busy/Transmit indicator lights red.
Talkgroup display on mode change
The Talkgroup ID (or name) is displayed for 2 sec on
the upper line of the LCD when the operating
channel or zone is changed. This function can be
turned OFF by your dealer.
Talkgroup display on PTT
The Talkgroup ID (or name) is displayed for 2 sec on
• Depending on the pre-set value, the target
station does not open the squelch, and
communication is not established, if the
Talkgroup ID or NAC (Network Access Code)
is not matched. Ask your dealer for details.
• The Talkgroup ID (or name) is displayed for
2 sec when [PTT] is pushed. (Depending on
the pre-set value.)
the upper line of the LCD when [PTT] is pushed.
This function can be turned OFF by your dealer.
■
Pager function
Transmitting
This function can be used as a “message pager” to
confirm the target station of a caller’s identification,
p )
4
Release [PTT] to receive.
Receiving
1
When a Talkgroup call is received;
• The Busy/Transmit lights green.
• The ringer sounds. (Depending on the pre-
setting.)
• The Talkgroup ID (or name) and calling
even when the operator leaves the transceiver
temporarily unattended. If the target station is active
when receiving a signal, an acknowledgement
is automatically transmitted. The caller station can
verify whether a target station is active or not.
[Digital Button] or [Digital Page] key assignment is
necessary to transmit the pager signal.
The Talkgroup ID (or name) and calling
station ID (or name) are displayed for 2 sec.
(Depending on the pre-set value.)
“ALL CALL” is displayed instead of the Talkgroup ID
(or name) when All Call is received.
•Depending on the pre-set value, the transceiver
does not open the squelch, and communication is
not established if the Talkgroup ID or NAC
necessary to transmit the pager signal.
▒ Not available on Non-display model.
1
Push [Digital Button] to enter the digital call type
selection mode.
not established, if the Talkgroup ID or NAC
(Network Access Code) is not matched.
▒
✔
Quick access
▒ Push [Digital Page] to directly enter the Individual
▒ ID selection mode. In this case, skip step
2
.
Talkgoup ID
40
The calling station
name ( or ID )