![background image](http://html2.mh-extra.com/html/icom/ic-7100/ic-7100_basic-manual_3602293030.webp)
2
INSTALLATION AND CONNECTIONS
2-6
The External Units Connections to a Transceiver
[DATA1] DATA1 JACK
For GPS operation (
FM sec. 10
)
• Connect a GPS receiver to the transceiv
-
er.
• The optional OPC-1529R (Data commu
-
nication cable) and a 3rd party's GPS re-
ceiver with RS-232C Port are required.
For low-speed data communication in the DV mode
(
FM sec. 9
)
• Connect the transceiver to a PC.
• The USB cable can also be used for low-speed data commu
-
nication..
OPC-1529R
(Optional)
[TUNER] TUNER CONTROL SOCKET (FM sec.16)
[SP] (EXTERNAL) SPEAKER JACK
(p. 2-4)
Similar to the [PHONES/SP] jack
on the controller. Plug in an exter-
nal speaker.
3.5(d) mm/
1
⁄
8
˝ plug
[USB] USB (Universal Serial Bus) PORT
•
Remotely control the transceiver using CI-V commands
(FM sec. 20)
•
Send the received audio to the PC
•
Input modulation (pp. 1-15, 6-8)
•
Send the decoded RTTY outputs to the PC
•
Low-speed data communication in the DV mode (FM sec. 9)
•
Cloning using the optional CS-7100
cloning
software
(FM sec. 19)
•
Remotely control using the optional RS-BA1
[DATA2]
DATA2 SOCKET
(
FM sec. 18)
Connect a TNC (Terminal Node Con-
troller) for packet communication.
[ACC] ACCESSORY
SOCKET (p. 1-16)
Connect control lines
for external equipment
such as TNC or a PC.
NOTE:
By setting “ACC/USB output selection” of the
Connectors Set mode (FM sec. 17), the receiving tone
can normally be output from the [ACC] socket, and
the [USB] port can output an IF signal (12 kHz). This
is required for the Software-Defined Radio (SDR) op-
eration. The Digital Radio Mondiale (DRM) broadcast
can be received using SDR.
CAUTION: DO NOT
connect any device to [RE-
MOTE] when cloning using the optional CS-7100
cloning
software
.
[REMOTE] REMOTE CONTROL JACK
• Remotely control the transceiver using CI-V commands.
(FM sec. 20)
•
Cloning between transceivers (FM sec.19)
3.5(d) mm/
1
⁄
8
˝ plug
Connect the con-
trol cable from an
optional AH-4 or
AH-740 (Automat-
ic antenna tuner).
AH-4
(Optional)
AH-740
(Optional)
AH-2b
(Optional)
•
Connected to AH-4