IC Bus BE Series, Руководство по эксплуатации и обслуживанию

Страница: 86 / 239

Passenger Control
System Deactivation
To deactivate the Post Trip Inspection (No Student Left Behind)
system once the system is triggered, the following steps must be
performed within 60 seconds (to avoid horn honking):
1. Turn the key to the ACC position and set the parking
brake.
2. As you proceed to the rear of the bus, check for children
that may be still on the bus. When you reach the rear of
the bus, lift then lower the rear emergency door lever. If
this bus is equipped with the post trip inspection RESET
BUTTON (located above the last window on the driver's
side) press and release the reset button.
3. The system is now deactivated, and the Instrument
Panel Gauge Cluster beep, headlights and horn should
now be off.
4. Move the key to the OFF position. Remove the key if
exiting the bus.
Snooze Mode
NOTE: The Snooze function can be turned Off before the
snooze time out period by placing the ignition switch to the
OFF position.
This function allows the driver to temporarily disable the No
Student Left Behind system activation, and is called the Snooze
mode. The purpose is to allow passengers to disembark the
vehicle without the No student Left Behind system triggering the
vehicle alarm.
This alternate operation allows the driver to turn Off the engine
while passengers enter or leave the vehicle.
Snooze Mode Initiation Procedure. To initiate the
Snooze feature, proceed and observe the following:
1. First, with the engine turned off, place the
ignition switch to the ON or ACC position.
2. Press and release the SNZ / NO STDNT
LEFT switch to the SNZ position.
3. The switch indicator will turn On, indicating
that the Snooze mode is active.
This
places the (No Student Left Behind) system in
“Snooze” (inhibits triggering of the vehicle alarm) for a
predetermined time (default 20 minutes).
74