IBM xSeries 365, Руководство по установке опций

Страница: 48 / 68

2. Move the cover-release latch to the open (up) position.
xS erie
s 3
65
Bezel
Top cover
Cover release
latch
3. Insert the tabs on the cover into the matching slots in the server chassis.
4. Press down on the cover-release latch. The cover-release latch slides the cover
forward into position and locks the cover in place.
5. Insert the tabs on the bottom of the bezel into the matching holes on the server
chassis.
6. Push the top of the bezel toward the server until the two tabs at the top of the
sides of the bezel snap into place. You might need to press the bezel side
latches as you perform this step.
7. Slide the server fully into the rack cabinet.
8. If you disconnected any power cords or external cables from the server,
reconnect the external cables first. If you are adding any new peripheral devices
(see “Connecting the cables” for details), you can connect the external cables
for those devices. Then, connect the power cords to properly grounded
electrical outlets.
Note: Depending on the options that you installed, you might need to run the
Configuration/Setup Utility program to update the server configuration. See
the User’s Guide for more information.
Connecting the cables
This section describes how to connect cables to the server, with particular
instructions for the RXE Expansion Port, RXE Management Port, and Ethernet
connectors. When instructed, see the applicable documentation for more details.
36
IBM xSeries 365 Type 8861 and 8862: Option Installation Guide