IBM xSeries 365, Руководство по установке опций

Страница: 44 / 68

Complete the following steps to replace the battery:
1. Review the safety information beginning on page v, and “Installation guidelines”
on page 11, and follow any special handling and installation instructions
supplied with the replacement battery.
2. Turn off the server and all peripheral devices. Disconnect all power cords; then,
disconnect all external signal cables from the server.
3. Remove the server cover (see “Removing the cover and bezel” on page 13).
4. Using the illustration at “I/O-board connectors, jumpers, and LEDs” on page 6
as a reference, locate the battery on the I/O board.
5. Remove the battery:
a. Use one finger to press the top of the battery clip away from the battery.
b. Lift and remove the battery from the socket.
6. Insert the new battery:
a. Position the battery so that the positive (+) symbol is facing away from you.
b. Use one finger to press the top of the battery clip away from the battery.
c. Press the battery into the socket until it clicks into place. Make sure that the
battery clip holds the battery securely.
7. Reinstall the server cover as described in “Installing the cover and bezel” on
page 35.
8. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Note: You must wait approximately 20 seconds after you connect the power
cord of the server to an electrical outlet before the power-control button
becomes active.
9. Start the Configuration/Setup Utility program and set configuration parameters.
v Set the system date and time.
v
Set the power-on password.
v Reconfigure the server.
See the section about using the Configuration/Setup Utility program in the
User’s Guide on the IBM xSeries Documentation CD for details.
32
IBM xSeries 365 Type 8861 and 8862: Option Installation Guide