IBM WebSphere DataPower 7198, Инструкция по установке и эксплуатации

Страница: 52 / 88

the DataPower firmware, and the locate LED is turned of when deactivated
by the DataPower firmware. For information about controlling this LED, see
“LEDs” on page 5.
C The green power LED indicates the status of the power source for the
appliance.
v
If illuminated, the appliance is turned on and fully functioning.
v If not illuminated, the appliance is turned off.
D The activity LEDs for Ethernet connections that indicate that traffic is passing
through the interface.
v
If illuminated, the Ethernet port is linking to the interface.
v
If illuminated and blinking, the Ethernet port is active.
E The activity LED for the hard drive.
v
If the green LED is illuminated, it indicates that the hard drive is active.
v
If the green LED blinks, it indicates that the hard drive is being accessed.
F The fault LED for the hard drive. If the amber LED is illuminated, it indicates
that the hard drive has failed.
Note: On Type 7198 appliances, the fault LED is nonfunctional.
G The speed LEDs for Ethernet interfaces that indicate the connection speed.
v
If these LEDs are illuminated in green, the connection speed is 1 Gbps.
v
If these LEDs are illuminated in amber, the connection speed is 10 or 100
Mbps.
H If the green LED on the 10 Gb SFP+ module is illuminated, the Ethernet port
is active and linking to the interface.
I The LEDs on the 10 Gb SFP+ module indicate the speed of the port.
v
If these LEDs are illuminated in green, the connection speed is 10 Gbps.
v If these LEDs are illuminated in amber, the connection speed is 1 Gbps.
LEDs on the rear panel
Figure 17 shows the LEDs on the rear of Type 7198 appliances.
Figure 18 on page 33 shows the LEDs on the rear of Type 7199 appliances.
A B C D E
Figure 17. LEDs on the rear on the Type 7198 appliance
32
Installation and User's Guide