IBM WebSphere DataPower 7198, Инструкция по установке и эксплуатации

Страница: 8 / 88

Norwegian
Les sikkerhetsinformasjonen (Safety Information) før du installerer dette
produktet.
Polish
Portuguese
Antes de instalar este produto, leia as Informações sobre Segurança.
Russian
Slovak
Slovenian
Pred namestitvijo tega proizvoda preberite Varnostne informacije.
Spanish
Antes de instalar este producto, lea la información seguridad.
Swedish
Läs säkerhetsinformationen innan du installerar den här produkten.
Guidelines for servicing electrical equipment
Observe the following guidelines when servicing electrical equipment:
v
Check the area for electrical hazards, such as moist floors, non-grounded power
extension cords, and missing safety grounds.
v
Use only approved tools and test equipment. Some hand tools have handles that
are covered with a soft material that does not provide insulation from live
electrical current.
v
Regularly inspect and maintain your electrical hand tools for safe operational
condition. Do not use worn or broken tools or testers.
v Do not touch the reflective surface of a dental mirror to a live electrical circuit.
The surface is conductive and can cause personal injury or equipment damage if
it touches a live electrical circuit.
v
Some rubber floor mats contain small conductive fibers to decrease electrostatic
discharge. Do not use this type of mat to protect yourself from electrical shock.
v
Do not work alone under hazardous conditions or near equipment that has
hazardous voltages.
v
Locate the emergency power-off (EPO) switch, disconnecting switch, or electrical
outlet so that you can turn off the power quickly in the event of an electrical
accident.
v
Disconnect all power before you perform a mechanical inspection, work near
power supplies, or remove or install main units.
v Before you work on the equipment, disconnect the power cord. If you cannot
disconnect the power cord, have the customer power off the wall box that
supplies power to the equipment and lock the wall box in the off position.
v
Never assume that power has been disconnected from a circuit. Check it to
make sure that it has been disconnected.
v
If you have to work on equipment that has exposed electrical circuits, observe
the following precautions:
vi
Installation and User's Guide