IBM WebSphere DataPower 7198, Инструкция по установке и эксплуатации

Страница: 74 / 88

A Release button. Press to open the lever to remove the module.
B Locking control. To unlock, move left. To lock, move right.
C Activity LED
D Fault LED. Nonfunctional on Type 7198 appliances.
To replace the hard disk drive module:
1. If the appliance is not turned off, perform a graceful shutdown by pressing
the power button on the front of the chassis. Because the appliance does not
provide feedback of a graceful shutdown, wait until the power LED is no
longer illuminated.
2.
Move the locking control to the left to unlock.
3. Press the blue button and the lever pops open. Figure 26 illustrates the
following steps.
a. Pull the lever toward you to pull out the hard disk drive module.
b. Pull the failed module out of the chassis.
4. Set aside the failed module.
Attention: Ensure that the gold connectors at the rear of the module do not
come into contact with your hands or with the packing material as you
unpack the replacement module. Avoid damaging the gold connectors against
the chassis as you insert the replacement module.
5.
Unpack the replacement module.
6. Carefully align the module, and insert into the chassis.
A
B C D
Figure 25. Controls and LEDs on the hard disk drive module
Figure 26. Removing a hard disk drive module
54
Installation and User's Guide