IBM WebSphere DataPower 7198, Инструкция по установке и эксплуатации

Страница: 35 / 88

To fully set up and test the appliance in your network, use the following high-level
processes:
1.
Install the appliance in a rack:
a. Install the rails in the rack.
b. Secure the appliance in the rack.
c. Connect the appliance to an AC source.
d. Connect the appliance to the network.
2. Set up the initial firmware configuration:
a. Connect the USB serial cable to the serial port.
b.
Initialize the appliance.
c. Verify the initial firmware configuration from the WebGUI.
3.
Define the base configuration.
Note: If the intrusion switch was tripped during installation, clear the
intrusion-detection (see “Consideration for the intrusion switch” on page
25).
Chapter 2. Preparing for installation
15