IBM WebSphere DataPower 7198, Инструкция по установке и эксплуатации

Страница: 53 / 88

The rear of the appliance has the following LEDs:
A, B, and C
The LEDs for a fan module indicate the following status:
v
If the amber LED is illuminated, there is a problem with the module.
v
If the LED is not illuminated, the module is operating normally.
D and E
The LEDs for a power supply module indicate the following status:
v
If the amber LED is illuminated, there is a problem with the module.
v
If the LED is not illuminated, the module is operating normally.
Testing the hardware from the command line
You can use the Global test hardware command to test the hardware from the
command line. To use this command:
v
You need to be able to establish a connection to the appliance.
v
You are in Global configuration mode (the
configure terminal
command).
To test the hardware from the configuration, enter the following commands:
# configure terminal
(config)# test hardware
Depending on the state of the hardware, the command produces output that shows
the status of each component:
v success
v warning
v failure
The components are broken down into the following categories:
v
Backtrace availability
v
Interface diagnostics
v
Fan diagnostics
v
Cryptographic card diagnostics
v RAID volume diagnostics
v
Sensors diagnostics
v CPU/memory diagnostics
Samples of
success
statements are as follows:
v [success] Backtrace file does not exist
A
C B D E
Figure 18. LEDs on the rear on the Type 7199 appliance
Chapter 5. Diagnosing your appliance
33