IBM TotalStorage SAN Volume Controller, Руководство по установке

Страница: 83 / 123

DANGER
You have already switched on the UPS 5115. The output sockets of the
UPS 5115 are live.
4. Place the free end of the SAN Volume Controller signal cable into the
Communication port
6
on the UPS 5115. See Figure 28 on page 52.
Attention: Do not plug any signal cables into the bottom row of signal cable
connectors or the UPS 5115 will malfunction.
The SAN Volume Controller power is connected to the UPS 5115.
Related tasks
“Inspecting the SAN Volume Controller for unsafe conditions” on page xix
Be cautious of potential safety hazards that are not covered in the safety
checks. If unsafe conditions are present, determine how serious the hazards are
and whether you should continue before correcting the problem.
“External machine checks” on page xx
Ensure that you perform an external machine check on the SAN Volume
Controller.
“Internal machine checks” on page xx
Ensure that you perform an internal machine check before installing the SAN
Volume Controller.
“Inspecting the uninterruptible power supply for unsafe conditions” on page xx
Ensure that you take the time to inspect the uninterruptible power supply (UPS)
for unsafe conditions.
Related reference
“Danger notices for the uninterruptible power supply” on page xvi
Ensure that you understand the danger notices for the uninterruptible power
supply (UPS).
“Danger notices for the SAN Volume Controller” on page xvii
Ensure that you are familiar with the danger notices on the SAN Volume
Controller.
“Caution notices for the uninterruptible power supply” on page xvii
Ensure that you understand the caution notices for the uninterruptible power
supply (UPS).
“Caution notices for the SAN Volume Controller” on page xviii
Ensure that you understand the caution notices for the SAN Volume Controller.
“Controls and indicators for the SAN Volume Controller” on page 5
Controls and indicators are located on the front panel of the SAN Volume
Controller.
“SAN Volume Controller rear panel indicators” on page 7
The controls and indicators for the SAN Volume Controller are contained on the
front and back panel assembly.
“Controls and indicators for the uninterruptible power supply 5115” on page 19
All controls for the uninterruptible power supply 5115 are located on the front
panel assembly.
Connecting the SAN Volume Controller to the uninterruptible power
supply 5125
There are a few restrictions you should be aware of before you connect the SAN
Volume Controller node to the uninterruptible power supply (UPS) 5125.
Chapter 3. Installing the uninterruptible power supply and the SAN Volume Controller
53
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|