IBM TotalStorage SAN Volume Controller, Руководство по установке

Страница: 22 / 123

8. Inspect the power supply assemblies and check that the fasteners (screws or
rivets) in the cover of the power-supply unit have not been removed or
disturbed.
9. Before connecting the SAN Volume Controller to the SAN, check the grounding.
External machine checks
Ensure that you perform an external machine check on the SAN Volume Controller.
Perform the following external machine checks before you install the SAN Volume
Controller:
1. Verify that all external covers are present and are not damaged.
2. Ensure that all latches and hinges are in the correct operating condition.
3. If the SAN Volume Controller is not installed in a rack cabinet, check for loose
or broken feet.
4. Check the power cord for damage.
5. Check the external signal cable for damage.
6. Check the cover for sharp edges, damage, or alterations that expose the
internal parts of the device.
7. Correct any problems that you find.
Internal machine checks
Ensure that you perform an internal machine check before installing the SAN
Volume Controller.
Perform the following internal machine checks before you install the SAN Volume
Controller:
1. Check for any non-IBM changes that might have been made to the machine. If
any are present, obtain the
″
Non-IBM Alteration Attachment Survey
″
form
number R009, from the IBM branch office. Complete the form and return it to
the branch office.
2. Check the condition of the inside of the machine for any metal or other
contaminants, or any indications of water, other fluid, fire, or smoke damage.
3. Check for any obvious mechanical problems, such as loose components.
4. Check any exposed cables and connectors for wear, cracks, or pinching.
Inspecting the uninterruptible power supply for unsafe conditions
Ensure that you take the time to inspect the uninterruptible power supply (UPS) for
unsafe conditions.
Consider the following conditions and the safety hazards they present:
Electrical hazards (especially primary power)
Primary voltage on the frame can cause serious or lethal electrical shock.
Explosive hazards
A bulging capacitor can cause serious injury.
Mechanical hazards
Loose or missing items (for example, nuts and screws) can cause serious
injury.
Be cautious of potential safety hazards that are not covered in the safety checks. If
unsafe conditions are present, determine how serious the hazards are and whether
you should continue before correcting the problem.
xx
IBM TotalStorage SAN Volume Controller: Installation Guide