IBM Tape Library Magstar 3494, Руководство оператора

Страница: 257 / 378

2. Go to the drive or storage cell and remove the cartridge. Verify that the cartridge
volser matches the volser specified on the action list.
Notes:
a. If the From location is a drive, remove the cartridge from the drive.
b. If the From location is followed by ?, the cartridge has already been used in
Manual mode. If the cartridge is not present in the indicated From location,
look in the location where you are storing demounted cartridges, for
example, the high-capacity output area.
3. Remove the cartridge from the enclosure or place it in a safe location. Be sure
to remove all ejected cartridges from the enclosure when Manual mode
operations are completed.
4. Confirm that the eject is complete as follows:
a. Highlight the action item to be confirmed on the Action List screen of the
library manager.
To highlight an item, use the up and down arrow keys to move the highlight
bar to the desired action item.
b. Confirm the highlighted action item by pressing the Enter key.
Note: Be sure to confirm each ejected cartridge after completing the eject task.
Eject actions remain on the Action List screen until they are manually
confirmed.
5. Press the Refresh key (F9) to update the list.
Reviewing Unknown Volume Locations
Use this procedure if you are not sure where a volume should go. You can display
the volser From location and To location of the last 20 completed actions. Use this
information to verify the accuracy of a completed action item.
1. Press the Review key (F6) on the Action List screen of the library manager. See
Figure 143 on page 230.
2. Return to the Action List screen by pressing F12.
If the volume was not listed on the Review List screen (see Figure 146 on
page 236), use the Locate Cartridge Home screen to find a storage cell in which to
put the volume. See Figure 148 on page 238.
Chapter 6. Advanced Operating Procedures
235