IBM System x3200 M3, Руководство по обслуживанию

Страница: 200 / 282

10. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing a USB embedded hypervisor flash device
To remove the virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 141.
2. Turn off the server and peripheral devices and disconnect all power cords; then,
remove the side cover (see “Removing the side cover” on page 145).
3. Unlock and remove the side cover (see “Removing the side cover” on page
145).
4. Unlock the USB retaining latch by squeezing the two retaining clips toward each
other. Then, lift up the bracket cover.
5. Grasp the flash device and pull to remove it from the connector.
6. Press down on the retention latch to return it to the locked position.
7. If you are instructed to return the flash device, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Installing a USB embedded hypervisor flash device
To install the virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 141.
2. Turn off the server and all attached devices; then, disconnect all power cords.
3. Unlock and remove the side cover (see “Removing the side cover” on page
145).
4. Unlock the USB retaining latch by squeezing the two retaining clips toward
each other.
5. Align the flash device with the connector on the system board and push it into
the connector until it is firmly seated.
6. Press down on the retaining latch to lock the flash device into the USB
connector.
180
System x3200 M3 Types 7327 and 7328: Problem Determination and Service Guide