IBM System x iDataPlex dx360, Руководство пользователя

Страница: 35 / 68

Installing an adapter
The following notes describe the types of adapters that the server supports and
other information that you must consider when you install an adapter:
v
Locate the documentation that comes with the adapter and follow those
instructions in addition to the instructions in this section. If you have to change
the switch setting or jumper settings on the adapter, follow the instructions that
come with the adapter.
v
The server comes with a one-slot PCI Express (PCIe) riser card. The riser card
slot supports PCIe x16 adapters.
Notes:
1. The one-slot riser card supports installation of only half-length, full-height
adapters.
2. The maximum power consumption from all supply voltages for a single PCIe
slot is the same as specified in PCI Local Bus Specification Revision 2.3 for
conventional slots (25 W).
To install an adapter in the system-board tray, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 17.
2. Turn off the system-board tray and all attached devices (see “Turning off the
system-board tray” on page 16).
3. If the system-board tray is installed in a chassis, remove it (see “Removing a
system-board tray from a 2U chassis” on page 19).
4. If a storage enclosure is installed on the system-board tray, remove it (see
“Removing a storage enclosure” on page 21); otherwise, remove the
system-board tray cover (see “Removing the system-board tray cover” on page
20).
5. Remove the riser card retaining screw on the front of the system-board tray.
Store the screw for future use.
Chapter 3. Installing optional devices
23