IBM System Storage TS7650G 3958 DD4, Инструкция по плану установки

Страница: 63 / 232

Table 6. Stand-alone gateway installation checklist (continued)
U
Task Description Where to find information
Section 4: Power-up all components
h
4–1 Turn on the breaker(s) to power the PDUs. N/A
h
4–2 Power-up the disk expansion module(s). “Disk expansion modules” on page 70.
h
4–3 Power-up the disk controller. “Disk controllers” on page 70.
h
4–4 Power-up the server. “Servers” on page 70.
h
4–5 Power-up the TSSC, display panel, and TSSC
Ethernet switch “TSSC and KVM kit” on page 71.
Section 5: Perform post-installation validation checks
h
5–1 Check power indicators for all components. “Visually inspecting indicator and fault LEDs”
on page 71.
h
5–2 Validate Ethernet link-up indicators on the
TSSC. “Visually inspecting indicator and fault LEDs”
on page 71.
h
5–3 Validate Ethernet link-up indicators on the
customer's local area network (LAN) to the
server and the TSSC. “Visually inspecting indicator and fault LEDs”
on page 71.
h
5–4 Validate fibre channel link-up indicators from
the disk controller to the server. “Visually inspecting indicator and fault LEDs”
on page 71.
h
5–5
Validate fibre channel (VTL) or Ethernet (OST)
link-up indicators from the customer host to
the server. “Visually inspecting indicator and fault LEDs”
on page 71.
Section 6: Prepare the TSSC for use with the TS7650G
h
6–1 Configure the TSSC's communication settings. “Setting up the TSSC for use with the
TS7650G” on page 77.
Section 7: Perform RAS package configuration and verification
h
7–1 Configure the RAS package on the server. Chapter 6, “Configuring the RAS package,” on
page 83.
h
7–2 Perform RAS verification. Includes verifying
attached systems and testing Call Home. Chapter 7, “RAS verification,” on page 91.
Section 8: SSR releases the system to trained ProtecTIER specialist or LBS representative
h
8–1 Configure ProtecTIER, including configuring
OST if applicable, and create the file system. Chapter 8, “Configuring ProtecTIER using
ptconfig,” on page 95.
h
8–2 Install the ProtecTIER Replication Manager
application, if applicable. Chapter 9, “Enabling the ProtecTIER
Replication Manager,” on page 111.
h
8–3 Install ProtecTIER Manager and create the
repository. Chapter 10, “Installing ProtecTIER Manager,”
on page 113.
h
8–4 Turn the system over to the customer. If
replication is being used, advise the customer
that it is their responsibility to create and
configure the replication grid. N/A
Chapter 4. Installing the TS7650G hardware
25
|||
|
| |
|
|||
| |
|