IBM System Storage TS7650G 3958 DD4, Инструкция по плану установки

Страница: 62 / 232

Table 6. Stand-alone gateway installation checklist (continued)
U
Task Description Where to find information
h
1–7 A separate USB keyboard and graphics-capable
monitor have been provided for use during
installation. Customer
h
1–8 If applicable, ensure that replication
configuration efforts are being coordinated
between the source and destination sites. Customer, LBS, and or trained ProtecTIER
specialist.
Section 2: Install the gateway components
h
2–1 Have the customer suspend all I/O activity.
Power-off any components that are
powered-on, and shut down power to the
frames. Refer to the component-specific documentation
for power-off instructions.
h
2–2 Install the server. “Installing the server” on page 30.
h
2–3a If the customer purchased a new TSSC and
TSSC Ethernet switch and has not yet installed
them, do so now then go to task 3-1. The TSSC Maintenance Information (MI),
provided on the IBM System Storage TS7650
with ProtecTIER Publications CD.
h
2–3b If the customer has an existing TSSC (with FC
2719) and TSSC Ethernet switch, that can be
used with the gateway, go to task 3-1.
N/A
Section 3: Apply cable labels and make cable connections
h
3–1 Label and connect the power cords on the
server to the PDU. “Cabling a stand-alone gateway” on page 35.
h
3–2 If you installed a TSSC, label and connect the
power cable on the TSSC to the PDU. “Cabling a stand-alone gateway” on page 35.
h
3–3 If you installed a TSSC Ethernet switch, label
and connect the power cable on the switch to
the PDU. “Cabling a stand-alone gateway” on page 35.
h
3–4 Label and connect an Ethernet cable from the
server to the TSSC's Ethernet switch. “Cabling a stand-alone gateway” on page 35.
h
3–5 Label and connect an Ethernet cable from the
server to the customer's LAN. “Cabling a stand-alone gateway” on page 35.
h
3–6
Label and connect Ethernet cables from the
server to the customer's replication network, if
applicable. “Cabling a stand-alone gateway” on page 35.
h
3–7 Label and connect an Ethernet cable from the
RSA on the server to the TSSC's Ethernet
switch. “Cabling a stand-alone gateway” on page 35.
h
3–8 Label and connect an Ethernet cable from disk
controllers A and B to the TSSC's Ethernet
switch. “Cabling a stand-alone gateway” on page 35.
h
3–9 Label and connect an Ethernet cable from the
TSSC's external port (Eth2) to the customer's
LAN. “Cabling a stand-alone gateway” on page 35.
h
3–10 Label and connect fibre channel cables from
the server to disk controllers A and B. “Cabling a stand-alone gateway” on page 35.
h
3–11a For VTL, label and connect fibre channel cables
from the server to the customer's host network. “Cabling a stand-alone gateway” on page 35.
h
3–11b For OST, label and Ethernetl cables from the
server to the customer's host network. “Cabling a stand-alone gateway” on page 35.
24
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
|||
| |
|||
| |
|||
| |