IBM System Storage TS7650G 3958 DD4, Инструкция по плану установки

Страница: 149 / 232

Chapter 9. Enabling the ProtecTIER Replication Manager
About this task
The ProtecTIER Replication Manager application is installed on a
customer-designated ProtecTIER v2.5 server. IBM recommends installing
ProtecTIER Replication Manager at the replication destination site, so that the
ProtecTIER Replication Manager will remain available in a disaster recovery
situation.
Note: If you are not enabling replication, proceed to Chapter 10, “Installing
ProtecTIER Manager,” on page 113.
Important: ProtecTIER Replication Manager requires access to TCP port 6202.
Before installing the ProtecTIER Replication Manager application, ensure that TCP
port 6202 is open in the customer's firewall. If port 6202 is behind the firewall, data
replication will fail.
Procedure
1. Log in to the ProtecTIER v2.5 server on which the ProtecTIER Replication
Manager application will reside:
a. Connect a USB keyboard and monitor (if not already present) to the server.
b.
Verify that the server is powered-on:
v If it is powered-on, go to step 2.
v
If it is not powered-on do so now, wait for the boot cycle to complete,
then go to step 2.
2. At the login: prompt, log in with the ID root and the password admin.
3. To activate the ProtecTIER Replication Manager enter the following commands:
cd /opt/dtc/install <enter>
./ptconfig -activatePTRepMan <enter>
Note: If in the future you should need to deactivate the ProtecTIER Replication
Manager, use the following command:
./ptconfig -deactivatePTRepMan <enter>
4.
The following ProtecTIER Replication Manager messages are displayed:
Are
you sure you want to activate the ProtecTIER Replication Manager on this
node? (yes|no)
Enter
yes
to activate the ProtecTIER Replication Manager or
no
if not activating the ProtecTIER Replication Manager.
5. The following ProtecTIER Replication Manager messages are displayed after
selecting
yes : Gathering information activatePTReplicationManager ended
successfully
6. Go to Chapter 10, “Installing ProtecTIER Manager,” on page 113.
© Copyright IBM Corp. 2008, 2010
111
|
|
|
|
|
|
|
|
|
|
|
|