IBM System Storage DS4000, Руководство по техническому обслуживанию аппаратной части, Страница: 149 / 184

Table 53. SDG Router service port commands (continued)
Group Description Page
diagHelp Displays a list of diagnostic commands 122
fcShow Displays the status of the fibre channel interface 122
fcShowDevs Displays information about the devices that are accessible from the fibre channel
interface
123
fcShowNames Displays the node and port names (addresses) of the fibre channel 123
hardwareConfig Diagnostic mode only . Stores FRU VPD information in the SDG non-volatile
memory (see sysVpdShow below)
124
help Displays a list of the commands 124
hlthChkHelp Displays the list of health check commands 125
hlthChkNow Initiates the health check for the SDG. Results display. 125
loggerDump Dumps records from the system event log to the terminal console 126
loggerDumpCurrent Dumps only the records that were logged since the system was last started. 126
macShow Displays the Media Access Control address for the Ethernet interface 127
mapShowDatabase Device database listing the connected devices 127
mapShowDevs Displays the cross-reference map of device addresses 127
normalBoot Restores the SDG to normal operating conditions. Used only to transition from
diagnostic mode to normal mode.
128
reboot Preferred method for restarting the SDG Router 128
scsiRescan Performs a rescan of the SCSI channel(s) to look for new devices 128
scsiShow Lists all SCSI channels and the attached devices for each channel 129
showBox Displays a picture of the SDG that shows the components present 130
sysConfigShow Displays current parameter settings. 130
sysVpdShow or
sysVpdShowAll
Displays Vital Product Data (VPD) information 130
targets Lists and describes each device currently attached 132
version Lists the firmware version level 132
The following descriptions are from Storage Area Network Data Gateway Router
Installation and User’s Guide ; they also are listed in the Storage Area Network Data
Gateway Router Service Guide .
diagBoot
Use the diagBoot command only to transition the SDG Router from normal
operation to the special diagnostic mode. The command first ensures that
the ffs0:mt directory exists, then it verifies that the files diagnstk.o and
diagnstk.rc are in the flash file system. If they are in the root directory, it
moves them to the ffs0:mt directory.
The diagBoot command copies the existing boot parameters to a file in the
ffs0:mt directory on the SDG Router. It then installs the new boot
parameters that direct the SDG Router to start using the special diagnostic
startup script, ffs0:mt/diagnstk.rc. It renames the persistent map file
config/device.map as config/device.bak. Finally, diagBoot issues a reboot
command to put the changes into effect.
Chapter 14. IBM Storage Area Network Data Gateway Router (2108-R03)
121