IBM Remote Supervisor Adapter II, Руководство пользователя

Страница: 37 / 132

System alerts
System alerts are generated for events that occur as a result of system
errors. If the Select all system alerts check box is selected, an alert
can be sent for any system alert.
Notes:
a. The Select all system alerts check box is not available on all
servers.
b. Hard disk drive Predictive Failure Analysis (PFA) alerts are not
monitored.
Table 4. System remote alerts
Alphanumeric
pager code
Alphanumeric
recovery code Event Action
20 70 POST timeout Generates an alert if an enabled POST timeout value is
exceeded. The POST timeout value is configured in the
Server Timeouts area on the System page.
21 71 O/S timeout Generates an alert if an enabled operating system timeout
value is exceeded. The operating system timeout value is
configured in the Server Timeouts area on the System
page. The O/S timeout alert must be checked to enable
remote operating-system-failure screen capture.
22 72 Test alert Generates an alert if the Generate Test Alert button is
clicked on the Remote Alert Recipients page.
23 73 Power off Generates an alert if the server is turned off.
24 74 Power on Generates an alert if the server is turned on.
25 75 Boot failure Generates an alert if an error occurs that prevents the
server from starting.
26 76 Loader timeout Generates an alert if an enabled server loader timeout value
is exceeded. The system loader timeout value is configured
in the Server Timeouts area on the System page.
27 77 PFA notification Generates an alert if a PFA notification is generated by the
server hardware. This feature is available only on servers
that have PFA-enabled hardware.
28 - 29 Reserved for future use.
38 88 Partition
configuration
Generates an alert if a partition configuration notification is
generated by the server. This feature is available only on
servers that have partitionable hardware.
39 89 Event log Generates an alert if the event log reaches 75% or 100% of
capacity, or if the log is cleared (Refresh 2 or later firmware
only).
4. Scroll to the bottom of the page and click Save .
Setting local events
Note: For the Remote Supervisor Adapter II SlimLine, the setting local events
feature is available only when using LAN-based alert functionality.
Complete the following steps to select the local events to which the Remote
Supervisor Adapter II will respond:
Chapter 3. Configuring the Remote Supervisor Adapter II
29