IBM PCI Dual Channel Ultra2 SCSI Adapter, Инструкция по установке и эксплуатации

Страница: 23 / 50

10. Check if the device driver is installed in the lppsource directory by typing:
cd /spdata/sys1/install/
<
lppsource_name
>
/lppsource
<
lppsource_name
>
was recorded in the previous step. Once in this directory,
type:
ls devices.pci.ðð1ððbðð.rte
ls devices.pci.ðð1ðð1ðð.com
ls devices.pci.ðð1ððfðð.rte
ls devices.common.IBM.scsi.rte
to see if the fileset is in the lppsource directory.
11. If the device driver is not in the lppsource directory, proceed to section
“Installing Software on the Control Workstation” on page 4-4 to install the
software.
12. Update the SPOT (Shared Product Object Tree) by doing the following:
a. Type
smitty nim_res_op
The Resource Name panel displays with
boot resources boot
highlighted.
b. Move the cursor down until the SPOT resource is highlighted. The
SPOT resource should look like:
spot_AIX433 resources spot
The format of the spot name is
spot_
<
lppsource_name
>
.
<lppsource_name>
was recorded in a previous step.
c. When the SPOT resource is highlighted, press Enter to select this
option. The Network Install Operation to Perform panel displays
with the reset option highlighted for selection.
d. Move the cursor until the cust option is highlighted and press Enter
to select this option. The Customize a SPOT panel displays with
the Source of Install Images highlighted for selection.
e. Press F4 to display the list of install images and select the
appropriate lppsource.
f. Move the cursor until the appropriate lppsource is displayed. For
example:
lppsource_AIX433 resources lpp_source
Chapter 4. Installing the Device Driver on the SP System
4-3