IBM PCI Dual Channel Ultra2 SCSI Adapter, Инструкция по установке и эксплуатации

Страница: 21 / 50

Chapter 4. Installing the Device Driver on the RS/6000 SP
System
In an SP System, you need to do on each node what you normally do on a
standalone system. You must make the installation files available and then install
them on all the relevant nodes.
Perform the following tasks on the Control Workstation. You should not need to
telnet or rlogin to the individual SP System nodes. You need to be familiar with the
dsh command. If not, refer to the Parallel System Support Program for AIX:
Administration Guide or Parallel System Support Program for AIX: Command and
Technical Reference.
If you are unable to utilize the "dsh" command because of the setup at your site,
then you have to telnet to each node and perform the steps below, omitting the "dsh"
prefix.
Check System Pre-Requisites
1. Log into the Control Workstation as root.
2. Go to a temporary directory by typing:
cd /tmp
then press Enter.
3. Make a "working collective" file containing a list of the relevant nodes on
which you want to perform the update in preparation for the dsh command.
Type the following and press Enter after each line:
cat
>
group1
nodename1
nodename2
nodename3......
CTRL-D
export WCOLL=/tmp/group1
4. Test the working collective by typing:
dsh date
then press Enter. The results should look similar to:
nodename1: Wed Apr 1ð 1ð:37:46 EDT 1996
nodename2: Wed Apr 1ð 1ð:37:46 EDT 1996
nodename3: Wed Apr 1ð 1ð:37:47 EDT 1996
nodename4: Wed Apr 1ð 1ð:37:48 EDT 1996
Chapter 4. Installing the Device Driver on the SP System
4-1