IBM PC 300PL Types 6862, Инструкция по использованию

Страница: 95 / 146

POST Message Description
1853
1854 A Plug and Play adapter has requested a memory address that is
not available, or the Plug and Play adapter might be defective.
Action:
1. Make sure that settings for all ISA legacy adapters are correct
in the Configuration/Setup Utility program. If the memory
address settings are not correct, change and save the settings.
Setting the resources used by ISA legacy adapters to Not
available
enables the Plug and Play function to configure
around the legacy adapters.
For background information on PCI, ISA, Plug and Play, and
legacy (non-Plug and Play) adapters, refer to Installing Options
in Your Personal Computer. For information about required
memory resource settings for ISA legacy adapters, refer to the
documentation that comes with these adapters. For
instructions on using the Configuration/Setup Utility program,
see “Using the Configuration/Setup Utility Program” on
page 33.
2. Make sure that switches on all ISA legacy adapters are set
correctly. For information about switch settings, refer to the
documentation that comes with the ISA legacy adapters.
3. If all memory addresses are being used by ISA legacy
adapters, you might need to remove an ISA legacy adapter to
make a memory address available to the Plug and Play
adapter you want to install. For instructions on removing
adapters, see Installing Options in Your Personal Computer.
Note: If you remove an ISA legacy adapter, set the memory
address used by the removed adapter to Available
before installing another adapter.
4. If you have other PCI or Plug and Play adapters installed, you
might need to remove one of these adapters to make a
memory address available to the Plug and Play adapter you
want to install.
5. If your system will be loading a Plug and Play operating
system, ensure that Plug and Play Operating System is set to
Yes
. See “Changing Plug and Play Control Features” on
page 39 for more information.
6. Ensure that the address decode value for the adapter is
properly set. See “Changing Plug and Play Control Features”
on page 39 for more information.
If the problem cannot be isolated and corrected, have the computer
serviced.
Chapter 6. Solving Problems
81