IBM PC 300PL Types 6862, Инструкция по использованию

Страница: 66 / 146

For additional information on this setting, refer to “Using System-Management
Features” on page 25 and “Wake on LAN” on page 54.
Note: To use Wake on LAN with an optional network adapter, the adapter
must support Wake on LAN and be properly configured.
Setting Automatic Power-On Features:
To set Automatic Power-On features,
complete the following steps.
1. Start the Configuration/Setup Utility program (see “Starting the
Configuration/Setup Utility Program” on page 34).
2. Select Advanced Power Management from the Configuration/Setup Utility
program menu.
3. Select Automatic Power On.
4. Select the menu item for which you want to view or change settings. Use Left
Arrow (
←
) or Right Arrow (
→
) to toggle between selections.
5. Refer to “Exiting from the Configuration/Setup Utility Program” on page 37 for
instructions on saving your settings and exiting from the Configuration/Setup
Utility program.
System-Management Settings
This section, which describes how to configure the network interface in your
computer, is intended primarily for network administrators. For further information
on the system-management capabilities of your computer, refer to “Using
System-Management Features” on page 25.
The Configuration/Setup Utility program includes settings that can be enabled and
disabled to configure the network interface in your computer. These settings are:
Ÿ
Ethernet Support
Ÿ
Remote Program Load (RPL) or Dynamic Host Configuration Protocol (DHCP)
Ÿ
Automatic Power-On Startup Sequence
Ÿ
Wake on LAN
Ÿ
Update POST/BIOS from Network
You can also view the MAC (media access control) address for the integrated
Ethernet controller of your computer in the Configuration/Setup Utility program.
To access the MAC address, select Devices and I/O Ports from the
Configuration/Setup Utility program menu, and then select Ethernet Setup. You
can view but not change the MAC address setting.
52
Using Your Personal Computer