IBM PC 300PL Types 6862, Инструкция по использованию

Страница: 80 / 146

To use the Configuration/Setup Utility program, do the following:
a. Select the menu item that is flagged (or that you wish to view) by pressing
Up Arrow (
↑
) or Down Arrow (
↓
), and then press Enter.
b. A new menu specific to the item that you selected appears. Press Left
Arrow (
←
) or Right Arrow (
→
) to toggle between choices for a menu item.
(Note that each menu item has a Help screen. To view the Help screen,
select the menu item, and then press F1.)
c. When you have finished viewing and changing settings, press Esc to return
to the Configuration/Setup Utility program menu.
d. Before you exit from the program, select Save Settings.
e. To exit from the Configuration/Setup Utility program, press Esc and follow
the instructions on the screen. When you exit from the Configuration/Setup
Utility program menu, your new settings will be saved and your operating
system will start automatically (unless there is an unresolved problem with
an IDE device).
6. For more information about what caused an error message to appear and what
action to take, refer to the following chart.
If you are unable to resolve a problem and need assistance, refer to Chapter 7,
“Getting Help, Service, and Information” on page 99.
Problem Go to:
POST error code or message appears. “POST Message Charts” on page 67.
After more than one beep, application
program or operating system appears.
“Diagnostic Programs” on page 95.
Blank screen, unreadable screen, or other
unusual response occurs.
“Troubleshooting Charts” on page 85.
66
Using Your Personal Computer