IBM P 615 series, Руководство по обслуживанию

Страница: 233 / 491

Error Code Description: Action/ Possible Failing FRU:
B1xx 8FF0 Informational message No action required. (The data in these informational log entries
may be used by support personnel to gather additional debug
information.)
For complete information regarding this error code, read through this entire section.
If the managed server is down, go to the service processor error log and find the error log entry containing
B1xx 8FF0. Examine the first two bytes of word 13 of the detailed entry information.
If the managed server is running, do the following:
v Examine the AIX error log entry containing B1xx 8FF0. This is a FIRMWARE_EVENT error with an
identifier of A6D1BD62.
v In the detail data, find the string B1xx 8FF0. (If present, it will be at byte 60 of the detail data.)
v Move forward 8 bytes to bytes 68 and 69; this is the value of word 13 in the service processor error log
entry.
If the system is running Linux, examine the Linux system log. The line(s) in the extended data that begin
with <4>RTAS: Log Debug: 04 contain the error code in the next 8 hex characters. (This error code is also
known as word 11). Each 4 bytes after the error code in the Linux extended data are another word. The 4
bytes after the error code are word 12 and the next four bytes are word 13. An example of the Linux
extended data, and finding words 11, 12, and 13, is shown in MAP 1321, step 1321-28, and step 1321-29,
in this service guide.
SPCN Informational Codes
The following values of word 13 indicate an SPCN informational message: C006, C007, C00C, C030,
C0E0, C0E2, C0F0. No action is required by the customer or service representative.
VPD Informational Codes
The following values of word 13 indicate a VPD informational message: E104, E10D, E112, E113, E114.
No action is required by the customer or service representative.
Scan Log Dump Progress Codes
A scan dump is the collection of chip data that the service processor gathers after a system malfunction,
such as a check stop or hang. The scan dump data may contain chip scan rings, chip trace arrays, and
SCOM contents. For more information on scan dumps, refer to “Scan Log Dump Policy” on page 233.
The following table shows the error code produced by a scan dump.
Error Code Description Action/Possible Failing FRU
A1FF 3000 Scan log dump request rejected This is an informational message. The service processor
firmware was not able to perform a scan log dump even
though one was requested.
D130 xxxx Scan log dump in progress Informational message only. As the dump progresses,
the xxx characters in the display changes. When
completed, the system may reboot, depending on the
reboot policy settings.
Chapter 5. Error Code to FRU Index
213