IBM P 615 series, Руководство по обслуживанию

Страница: 213 / 491

Table 6. Service Processor Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
406x 00B3 Processor/VPD failure
1. Check for system firmware updates. Apply if
available.
2. Replace the service processor, location:
U0.1-P1-X1
3. Replace the CEC backplane, location:
U0.1-P1
406x 00B7 Insufficient hardware resources were detected to
continue IPL of the system after processor sub
system testing and initialization was completed.
Go to “MAP 1540: Problem Isolation Procedures”
on page 110
406x 00D1 Informational message Informational message
406x 0100 Memory quad A failure Go to “MAP 1240: Memory Problem Resolution”
on page 69
406x 0101 Memory quad B failure Go to “MAP 1240: Memory Problem Resolution”
on page 69
406x 0A03 Reboot message (run-time array gard failure) for
processor 0.
Array bit steering, which is a function in the
firmware, may be able to correct this problem
without replacing hardware.
If AIX is available on the system, go to
″
MAP
0235: System Array Self-Repair Problem
Resolution
″
in the RS/6000
Eserver
pSeries
Diagnostic Information for Multiple Bus Systems .
If Linux is the only operating system on the
system, schedule deferred maintenance with the
customer. When it is possible to reboot the
system, do the following:
1. Using the service processor’s system power
control menu, disable fast mode boot.
(Disabling fast mode automatically enables
slow mode.)
2. Boot the AIX diagnostic CD-ROM.
3. Run diagnostics in problem determination
mode. If no errors are recorded against any
of the processors (devices with a resource
name of proc x ), array bit steering was
successful and the problem has been
corrected.
If errors are reported against the hardware,
follow the actions for the error code or SRN.
406x 0B00 Problem with internal RIO interface CEC backplane, U0.1-P1
406x 0B01 Problem with internal RIO interface CEC backplane, U0.1-P1
406x 0BF0 Problem with RIO interface (I/O slot 0, I/O port
3)
1. Check for system firmware updates.
2. CEC backplane, U0.1-P1
3. Call service support.
406x 0C10 Proc 0 config error: VPD mismatch for proc card
0. (Service processor code problem.)
1. Check for system firmware updates.
2. Call service support.
Chapter 5. Error Code to FRU Index
193