IBM P 615 series, Руководство по обслуживанию

Страница: 85 / 491

Symptom Action
The system stopped and a code is displayed on the
operator panel.
Go to the “Quick Entry MAP” on page 55.
The rack identify LED does not operate properly. Go to the “Entry MAP” on page 53.
The system stops with a prompt to enter a password. Enter the password. You cannot continue until a correct
password has been entered. When you have entered a
valid password, go to the beginning of this table and wait
for one of the other conditions to occur.
The diagnostic operating instructions are displayed. Go to
″
MAP 0020: Problem Determination Procedure
″
in
the RS/6000
Eserver
pSeries Diagnostic Information for
Multiple Bus Systems .
The system login prompt is displayed. If you are loading the diagnostics from a CD-ROM, you
may not have pressed the correct key or you may not
have pressed the key soon enough when you were trying
to indicate a service mode IPL of the diagnostic
programs. If this is the case, start again at the beginning
of this step.
Note: Perform the system shutdown procedure before
turning off the system.
If you are sure you pressed the correct key in a timely
manner, go to “Step 1020-2” on page 67.
If you are loading diagnostics from a NIM server, check
for the following:
v The bootlist on the client may be incorrect.
v Cstate on the NIM server may be incorrect.
v There may be network problems preventing you from
connecting to the NIM server.
Verify the settings and the status of the network. If you
continue to have problems refer to “Boot
Problems/Concerns” on page 155 and follow the steps for
network boot problems.
The system does not respond when the password is
entered.
Go to “Step 1020-2” on page 67.
Chapter 3. Maintenance Analysis Procedures (MAPs)
65