IBM NetVista, Руководство по техническому обслуживанию аппаратной части

Страница: 73 / 155

73
Factory-Installed Modem Card
001 - START
Power off the system unit.
In Windows Device Manager, make sure that the modem is not configured with a conflicting COM port and IRQ setting.
Make sure that the communication software is configured with the correct COM and IRQ settings (same COM port and
IRQ as the modem).
Make sure that all communication parameters (baud rate, data, stop and parity bits) are properly configured and are
identical on both sides.
Connect the phone line to the LINE port of the modem card.
NOTE:
Check the outside phone line by connecting a working telephone to the telephone wall jack. Listen for a dial
tone to ensure that the phone line is good.
002 -
Insert the diagnostics diskette into the diskette drive.
Power on the system unit.
Select
Diagnostics
menu,
Select
All Tests,
then execute
Modem
test.
003 - DOES THE MODEM PASS THE TEST? (YES, READ AHEAD. NO, GO TO STEP 004.)
Power off the system unit.
Remove all adapter cards.
Connect a hard disk drive with pre-loaded Windows Millennium.
Power on the system unit.
Perform the following steps under Windows Millennium.
NOTE:
If an operating system other than Microsoft Windows Millennium is installed, the program screens and icons
may differ from these instructions.
1. Start Microsoft Windows Millennium.
2. Select the
Start
icon.
3. Select
Program
, then select
Accessories
,
Hyper Terminal
.
4. Select an
on-line service station
, dial and connect to it.