IBM iSCSI Host Bus Adapter, Руководство пользователя

Страница: 30 / 62

v
On the lower pane is the Fast!UTIL Options pane.
Configure the boot iSCSI HBA
Some of the iSCSI HBA settings depend on what addressing mode is being used. These are described in
the following sections.
Select one of the two procedures listed below, based on the boot parameter delivery method selected in
worksheet item RS6
v
When configuring a new iSCSI HBA (one that has not been previously configured) for dynamic
parameter delivery via DHCP, complete the steps in “Configure a new iSCSI HBA for dynamic
addressing.”
v
When the iSCSI HBA may have been previously used follow the directions for “Resetting the cached
iSCSI initiator configuration information” on page 31 followed by “Restore the factory defaults” on
page 31 before continuing with “Configure a new iSCSI HBA for dynamic addressing.”
v
To configure your iSCSI for manual addressing see, “Configure iSCSI HBA for manual addressing” on
page 19.
Note: These procedures start from the Configuration Settings menu if you need to restore this menu see,
“Start the iSCSI HBA configuration utility” on page 17 then return to this procedure.
Configure a new iSCSI HBA for dynamic addressing
Learn how to use the configuration utility to prepare the iSCSI HBA for dynamic addressing. Use the
procedure in this section to accomplish this task.
Note: These procedures start from the Configuration Settings menu if you need to restore this menu see,
“Start the iSCSI HBA configuration utility” on page 17 then return to this procedure.
1.
Highlight Host Adapter settings using the up or down arrow keys and press Enter
2. Highlight Initiator IP address by DHCP using the up or down arrow keys and press Enter until the
value shows NO .
3. Press Esc to return to the Configuration Settings menu.
4. Highlight ISCSI Boot Settings using the up or down arrow keys and press Enter.
5. The iSCSI Boot Settings menu will be displayed.
6. Highlight Adapter Boot Mode using the up or down arrow keys and press Enter.
7. Highlight DHCP using the up or down arrow keys and press Enter.
v
For adapter version 406x highlight
DHCP using vendor IP
using the up or down arrow keys and
press Enter
8. Highlight Primary Boot Device Settings using the up or down arrow keys and press Enter.
9.
Highlight Security Settings using the up or down arrow keys and press Enter to select. The next
menu displayed will be the Primary Boot Security Settings menu.
10. Highlight Chap using the up or down arrow keys and press Enter to change the value to Enabled or
Disabled , depending on whether or not CHAP will be used. Refer to the iSCSI Network Planning
Worksheets item CQ12 for this information. Skip to step 13 if CHAP has been disabled.
11. Highlight Chap Name using the up or down arrow keys and press Enter. This will bring up the
Enter Chap Name pane. Type in the CHAP name from the iSCSI Network Planning Worksheets item
CQ13 and press Enter.
12.
Highlight
Chap Secret
using the up or down arrow keys and press Enter. This will bring up the
Enter New Secret
pane. Type in the CHAP secret from the iSCSI Network Planning Worksheets item
CQ14 and press Enter. The Confirm New Secret pane is then displayed. Retype the same secret and
press Enter.
13. Press Esc to return to the Primary Boot Device Settings menu.
14. Press Esc to return to the i SCSI Boot Settings menu.
18
System i and System p: iSCSI Host Bus Adapter for IBM BladeCenter, System x, or xSeries