IBM IntelliStation 6836, Руководство по техническому обслуживанию аппаратной части

Страница: 43 / 164

v
The drives that are preinstalled in your computer come with power and signal
cables attached. If you replace any drives, it is important to remember which
cable is attached to which drive.
v
When you install a drive, ensure that the drive connector at the end of the signal
cable is always connected to a drive; also, ensure that the drive connector at the
other end is connected to the system board. This reduces electronic noise from
the computer.
v
If two IDE devices are used on a single cable, one must be designated as the
primary or master device and the other as the secondary or subordinate device;
otherwise, some of the IDE devices might not be recognized by the system. The
primary and secondary designation is determined by switch or jumper settings
on each IDE device.
v
If two IDE devices are on a single cable, and only one is a hard disk drive, the
hard disk drive must be set as the master device.
v
If you have only one IDE device on a cable, it must be set as master.
Type 6836 - Major components
Note: The illustrations in this document might differ slightly from your hardware.
The following illustration shows the locations of major components in your
desktop model.
Cover
Drive cage
Drive cage
Adapter
retaining
bracket
Microprocessor
Memory modules
EMC shield
Removing the computer cover
The following information describes how to remove the computer cover.
Chapter 5. Installing options Type 6836, 6846
35