IBM Infoprint 6500-v05, Руководство по обслуживанию

Страница: 81 / 544

Display Messages
81
084 POWER 48V CHECK *
SEE USERS MANUAL (continued)
10. The 084 message still occurred when each of the above cables were individually unplugged during
step 9.
11. Power off and unplug the printer. Reconnect all cables to the controller board and PS.
12. Plug in the printer and power it on. If the 084 message appears, contact DDS and Boulder support. Exit
this procedure.
13. The printer comes on READY. If the controller was not replaced during the above procedure, print the
error log. Look for the the last errors that are not the 084 message. Investigate the other reported errors
by following the appropriate procedure in this manual.
14. Go to “OPERATOR PRINT TESTS” in the configuration menu and print a full 136 character width test
pattern of All H’s. If there is any print quality issue, go to the appropriate procedure in this manual.
Table 3. Message List
Operator Panel Message Explanation Corrective Action
Disconnect Plug under
test. All others are
connected.
Expected Fan result if
+48 V is OK
Expected Operator
Panel Result
Comments
P122 for model v20 CCF comes on READY or
TABLE MISMATCH Do hammer bank and
shuttle checks.
P02 on PS, ribbon cable
for model v20 CCF on momentarily (1
second) TABLE MISMATCH
DOWNLOAD AGAIN +48 V is OK. Do P02
cable checks.
P03 on PS for model v20 CCF comes on HAMMER BANK NOT
INSTALLED message
(momentarily). TABLE
MISMATCH /
DOWNLOAD AGAIN +48 V is OK. Do P03
cable and shuttle checks.