IBM Infoprint 6500-v05, Руководство по обслуживанию

Страница: 71 / 544

Display Messages
71
080 POWER SUPPLY HOT The printer has sensor circuits
that sample the operating
temperature of key components of
the power supply. When higher
than normal temperatures are
sensed, print speed is
automatically reduced. If the
printer runs at reduced speed for
an extended period of time, the
POWER SUPPLY HOT message
is sent to the LCD and printing
stops, allowing printer
components to cool down.
Pressing the
START key resumes
the print task. Check the operating
environment. A severe
environment is one with an
ambient temperature at or above
above 40
°
Celsius (104
°
Fahrenheit) or is dirty enough to
create blockage of the cabinet fan
vents. The printer must never be
run at ambient temperatures
greater than 40
° Celsius (104 °
Fahrenheit). If the printer is
located in such an environment,
relocate it to a cooler, cleaner
area.
1. Inspect printer environment for severity. Advise the user to move
the printer to cooler, cleaner location.
2. Run a print test. If the message appears, do the power supply
operational check (page 258). If the power supply fails the check,
replace it. If it passes the check, go to the next step.
3. Check the kinds of print jobs the user is running: look for very
dense graphics and layouts. Advise the user to run jobs in smaller
batches.
4. Power off and unplug the printer. Remove the paper guide
assembly or pedestal top cover. Check that the power supply
guard/air deflector is correctly positioned over the power supply
board.
CAUTION: DO NOT TOUCH THE POWER SUPPLY , but
hold your hand close enough to it to check for heat radiating off
the power supply board. If the power supply is noticeably hot,
replace it.
5. Check that all fan cables are connected.
6. Inspect vents and fan airways for obstructions. Look underneath
cabinet models for items blocking the cabinet exhaust vents.
7. Replace the power supply if you did not do so earlier.
8. Install paper guide assembly or pedestal top cover. Plug in the
printer and power it on. Load paper. Run the “All E’s” print test for
5 to 10 minutes. If the problem reappears, the controller board or
microcode is suspect. Do the following:
9. Save the printer configuration values. (Refer to the User’s
Manual.)
10. Clear NVRAM (page 237).
11. Download and install the latest code from IBM First (page 231).
Table 3. Message List
Operator Panel Message Explanation Corrective Action