IBM eServer xSeries 235 Type 8671, Техническое обслуживание и устранение неисправностей

Страница: 126 / 214

9. From outside the server, push the tab
1
on the panel
2
, making sure to
press the tab near the chassis; the panel will disengage from the chassis.
10. Remove the panel, carefully threading the cable past the other components
and through the opening in the chassis.
Note: If the cable has been secured in the cable clamps, gently pull it out of
the clamps before pulling the cable through the opening in the chassis.
11. To install the operator information panel, reverse the previous steps.
Notes:
a. Thread the cable through the opening in the chassis and extend it into the
server before attaching the operator information panel.
b. Secure the cable in the cable clamps along the inside of the chassis.
c. Fit the left tab (in the rack configuration, this is the top tab) into the lip on
the chassis, and then press on the right tab (in the rack configuration, this
is the bottom tab) until it snaps into place.
Diskette drive
Complete the following steps to remove the diskette drive.
Note:
v
Read “Installation guidelines” on page 41.
v Read the safety notices at “Safety information” on page 163.
v Read “Handling electrostatic discharge-sensitive devices” on page 166.
1. Turn off the server and all attached devices.
2. Disconnect all external cables and power cords from the back of the server.
3. Remove the server cover (see “Removing the left-side cover” on page 51).
116
xSeries 235 Type 8671: Hardware Maintenance Manual and Troubleshooting Guide