IBM eServer xSeries 226Type 8648, Руководство по установке опций

Страница: 53 / 76

5. Verify that the dc power LED and the ac power LED on the power supply are lit,
indicating that the power supply is operating properly.
Completing the installation
To complete the installation, you must reinstall the bezel, reinstall the frame-support
bracket (see “Removing and installing the support bracket” on page 12), reinstall
the side cover, connect all the cables and, for certain options, run the
Configuration/Setup Utility program. Follow the instructions in this section.
Replacing the bezel
Complete the following steps to replace the bezel.
Openings
Hooks
Tab
Bezel
Note: For hot-swap hard disk drive models, make sure the side cover is unlocked;
then, slide the lock bar on the bezel to the left (unlocked) before you begin.
1. Insert the two hooks on the bottom rear of the bezel onto the matching
openings on the server chassis.
2. Insert the tab on the left side of the bezel into the matching hole on the chassis
left front.
3. Push the top of the bezel toward the server until the two tabs at the top of the
bezel snap into place.
4. For hot-swap hard disk drive models, slide the lock bar to the right. The
hot-swap lock bar locks when you lock the side cover key lock.
5. Lock the side cover.
Replacing the side cover
If you removed the support bracket or bezel, reinstall it before you replace the side
cover. See “Removing and installing the support bracket” on page 12 and
“Replacing the bezel.”
Chapter 2. Installing options
41