IBM eServer xSeries 226Type 8648, Руководство по установке опций

Страница: 28 / 76

down into the connector by applying pressure on both ends of the DIMM
simultaneously. The retaining clips snap into the locked position when the
DIMM is firmly seated in the connector. If there is a gap between the DIMM
and the retaining clips, the DIMM has not been correctly installed. Open the
retaining clips, remove the DIMM, and then reinsert it.
8. If you have other options to install or remove, do so now; otherwise, close the
microprocessor air baffle (see “Opening and closing the microprocessor air
baffle” on page 12), replace the support bracket (see “Removing and installing
the support bracket” on page 12) and go to “Completing the installation” on
page 41.
Installing a drive
Depending on your server model, one or more of the following drives might be
installed in the server:
v Diskette
v
Hard disk drive
v
CD-ROM
Internal drive bays
The server comes with an IDE CD-ROM drive in bay 1 and a 3.5-in., 1.44 MB
diskette drive in bay 3. Some server models come with six hot-swap hard disk drive
bays; other server models come with four simple-swap hard disk drive bays and a
hard disk drive installed in bay 7.
Server with hot-swap hard disk drives
Bay 1
Bay 2
Bay 3
Bay 5
Bay 6
Bay 7
Bay 8
Bay 9
Bay 4
16
xSeries 226 Type 8648: Option Installation Guide