IBM eServer xSeries 205 Type 8480, Руководство по техническому обслуживанию и ремонту

Страница: 50 / 168

4. Align the post in the center of the foot with the hole on the bottom of the server
and place the foot between the guides as indicated.
Note: The following illustration shows the rear feet located on the bottom rear
of the server.
Feet (locked position)
Guides
Guides
5. Rotate the foot outward until the foot locks into place.
6. Complete steps 2 through 5 for each foot.
Attention: When you need to access the inside of the server to install options,
you might find it easier to lay the server on its side. If you do so, make sure the
feet are in the horizontal position (see the previous steps). Otherwise, the feet
might break off from the server because of the weight of the server.
Removing the side cover
Complete the following steps to remove the side cover of the server.
Note: To remove the side cover, you might find it easier to lay the server on its
side. If you do, move the stabilizing feet so that they do not break. See
“Moving the stabilizing feet” on page 39.
1. Review the information in “Installation guidelines” on page 38 and “Safety
information” on page 117.
2. Turn off the server and all attached devices.
3. Disconnect all external cables and power cords.
40
IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide