IBM eServer xSeries 205 Type 8480, Руководство по техническому обслуживанию и ремонту

Страница: 92 / 168

Handle assembly
Before you begin:
v Read “Safety information” on page 117.
v
Review the information in “System reliability considerations” on page 33.
To remove the handle cap, complete the following steps:
1. Turn off the server, if it is on.
2. Unplug the server.
3. Use a flathead screwdriver to gently press in and down on the tabs located on
the interior side wall of the handle.
Tab locations
4. Lift up on the handle cap to separate it from the handle support.
5. Turn the system back to the tower-orientation; then, remove the top handle.
a. Carefully use a flat-blade screwdriver to push in the tabs inside the plastic
cover on the top of the system; then, remove the plastic cover. Store the
cover for possible future use.
b. Grasp the metal handle and slide it toward the rear of the system to remove
it from your system. Store the metal handle for possible future use.
To remove the handle support, complete the following steps:
1. Turn off the server, if it is on.
2. Unplug the server.
3. Firmly grasp the handle support and slide it away from the front bezel.
4. Lift up on the handle support to remove it from the slots in the top of the
chassis.
82
IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide