IBM eServer xSeries 205 Type 8480, Руководство по техническому обслуживанию и ремонту

Страница: 108 / 168

Note: See “System” on page 110 to determine which components should be replaced by a field service technician.
Error code/symptom FRU/action
00012000 (Machine check architecture
error.)
1. Microprocessor.
2. System board.
00019701 (Microprocessor 1 failed)
1. Microprocessor.
2. System board
00180200 (No more I/O space available
for PCI adapter.)
1. Run the Configuration/Setup Utility program.
2. Adapter.
3. System board.
00180300 (No more memory above 1MB
for PCI adapter.)
1. Run the Configuration/Setup Utility program.
2. Adapter.
3. System board.
00180500 (PCI option ROM checksum
error.)
1. PCI adapter.
2. System board.
00180600 (PCI device BIST failure. PCI
bridge error.)
1. Run the Configuration/Setup Utility program.
2. Adapter.
3. System board.
00180700 (PCI device no responding.)
1. System board.
2. PCI adapter.
00181000 (General PCI error)
v
Adapter
v
System board
I9990650 (AC power has been restored)
1. Check cable.
2. Check for interruption of power.
3. Power cable.
POST (ISPR) error procedures
Use the ISPR error procedures to help you solve ServeRAID problems. A complete
list of error codes is listed at “ServeRAID error codes” on page 100.
Note: Where the ISPR Error Procedures refer to a Hard disk drive backplane, see
the chapter of this publication that concerns service replaceable units.
EF10 (Default ISPR)
1. No ISPR error present.
9 ZXX thru B ZXX (SCSI bus error caused either by cables, termination, defective
drives, etc.)
1. Isolate between SCSI subsystem and controller by disconnecting all hard disk
drive cables from suspect card, and reboot.
CAUTION:
Do not press F5. Doing so changes the server’s configuration.
If an ISPR error is still present, perform the following actions until the error is no
longer present:
a. Reseat the controller
98
IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide