IBM eServer 370 xSeries, Руководство пользователя

Страница: 70 / 218

Refer to the following illustration while you perform the steps in this procedure.
Note: The illustrations in this section might differ slightly from your hardware.
1
Latches
2
Retaining clips
3
DIMM
Before you begin:
Read the documentation that comes with your option.
To install a DIMM:
1. Read “Safety information” on page 39 through “Handling static-sensitive
devices” on page 43.
2. Run the shutdown procedure for the operating system. Turn off the server and
peripheral devices; then, remove the front bezel (see “Removing the front
bezel” on page 50) and the memory-access panel (see “Removing the
memory-access panel” on page 51).
3. If you are not installing an optional memory board, continue with step 4.
If you are installing an optional memory board, touch the static-protective
package containing the memory board to any unpainted metal surface on the
server. Then, remove the memory board from the package. Continue with
step 5.
4. Remove the memory board from the server:
a. Pull both latches
1
simultaneously so that they fully extend from the
memory board.
b. Grasp the two latches and pull the memory board from the server.
c. Place the memory board connector-side up on a flat, static-protective
surface.
5. Touch the static-protective package containing the DIMM to any unpainted
metal surface on the server. Then, remove the DIMM from the package.
54
xSeries 370 User's Reference